JB Bond

JB-BOND

 JB Bond is a bonding agent provides excellent performance to bond Gypsum Plaster /Sand Cement Plaster on smooth low suction internal RCC surfaces and it eliminate hacking roughening and putting wire mesh on concrete surface. It is a specially formulated ready to Use adhesive consist of organ resins with additives.

Introduction

JB Bond is a bonding agent which provides excellent performance to bond Gypsum Plaster /Sand Cement Plaster on smooth low suction internal RCC surfaces and it eliminate hacking roughening and putting wire mesh on concrete surface. It is a specially formulated for ready to use adhesive consisting of organ resins with additives.

How it Works
The unique high polymer based formulation is one of unique formulation in the emulsion state which can bind the Concrete and Plaster of Paris together. Some of the unique properties of the bonding adhesive are listed.
Free of POP

The formulation is free of POP and it is a water based emulsion of high polymer which has been stabilized under neutral conditions. The formulation is designed for ready to use.

Environment Friendly

The formulation is water based and thus has pH in the range of 7-8. The near neutral pH of the solution is not harmful for the worker and thus offers safety of the workers.

High Adhesion

 It offers outstanding adhesion with so high that it is hard to break with hammer in comparison with available solutions. This formulation can provide high adhesive strength due to inter locking of the POP created in the micro voids created in the film as shown in the Image. The both mechanical locking of the POP and chemical interaction with POP are able to provide outstanding adhesion.

High Coverage

This adhesive formulation has low wet density of 0.928 g/cm since it contains more amount of high polymer than fillers. It also results in high coverage to the range of 6 sq.mt. per kg. depending upon background surface and its suction properties.

How to Apply

 The bonding agent should be well shaken before applying the same on well cleaned surface. The surface should be cleaned with a piece of soft cloth and should be free of oil or any other organic matter. One coat of the film should be made with the help of Brush. The formulation can not be diluted by the addition of water and the addition of any other additive is not recommended. The formulation should be stored in clean ,dry & sealed container. The sealed container should be avoided from the exposure of direct Sunlight.

Apply Timing

Gypsum Plaster will be applied any time once JB Bond dries completely on the surface approximate time for drying is 24 hours. (Again it would depend on the climate conditions and location.)

Product Features
  • Ready to apply and not to be mixed or diluted
  • To be applied as a single coat
  • Apply with the help of 4"-6" Bristles Brush (used for wall painting)
  • Simple PaintApplication
  • Contains fine aggregates to impart better mechanical bond.
  • JB Bond formulation is only the bonding agent which imparts both mechanical & chemical bond.
    • Mechanical Bond - Imparted by the suspended fine aggregates which are • inert pure white in Colour.
    • Chemical Bond imparted by Dry Polymeric Film Green in colour easy to • identify applied surface.
Caution
  1. Wash hand with water after use.
  2. Keep away from Eye contact in case of Eye contact wash eye thoroughly with water, if the irritation persists kindly consult Physician. If at all spills on clothes wash them with plain water immediately.

JB INDUSTRIES

GET IN TOUCH

11 KM STONE

NEAR HISAR CANTT, DEHLI ROAD

HISAR- 125001

Mobile: +91- 92152 01977, 92151 91450, 94160 43441

Email: jbplaster@rediffmail.com,

jbindustrieshissar@gmail.com